自動攪拌一體車在進行運輸重載混凝土的時候會進行試運轉,那么你知道它是如何進行試運轉的嗎?下面為大家介紹一下步驟。
The automatic mixer will be put into trial operation when transporting heavy-duty concrete. Do you know how it is put into trial operation? Let's introduce the steps.
1、按所需混凝土配比確定供水量,并調節時間繼電器到相應的給水時間。
1. Determine the water supply according to the required concrete ratio, and adjust the time relay to the corresponding water supply time.
2、啟動攪拌電動機運轉。
2. Start the mixing motor for operation.
3、關閉卸料門,在料斗內加入所需的混合料后,提升料斗,料斗應運行平穩并能自如停止在軌道的任意位置,若有打滑現象,應先將料斗放入坑底,然后調整制動電機上的大螺母。料斗提升正常,制動可靠后,向攪拌罐內投料,同時啟動水泵向攪拌罐內供水。
3. Close the discharge door and add the required mixture into the hopper. After lifting the hopper, the hopper should run smoothly and stop at any position of the track freely. If there is slippage, the hopper should first be put into the bottom of the pit and then adjust the large nut on the brake motor. After the hopper is lifted normally and the braking is reliable, feed into the mixing tank, and start the water pump to supply water to the mixing tank.
4、攪拌25—35秒后,啟動卸料門卸料。
4. After 25-35 seconds of mixing, start the unloading door for unloading.
5、在上述各項試運轉過程中,如發現不正常情況,應立即停機檢查,排除故障,然后再次試驗,直到正常為止。
5. If any abnormality is found during the above test run, stop the machine immediately for inspection, eliminate the fault, and then test again until it is normal.
自動攪拌一體車的重載試運轉就是上面介紹的這個樣子,車輛在重載時進行試運轉是非常有必要的,司機師傅們一定要注意了。以上內容由山汽機械為大家整理發布的,希望可以幫助到大家,更多精彩內容直接關注http://www.sooezi.com會有更多精彩內容為大家呈現。
The heavy load test run of the automatic mixer is the way described above. It is very necessary for the vehicle to carry out the test run during heavy load. The drivers must pay attention to it. The above content is compiled and released by Shanqi machinery. I hope it can help you and pay more attention to it directly http://www.sooezi.com There will be more wonderful content for you.