攪拌一體機的輪胎多少時間更換？_公司新聞_新聞資訊_自動攪拌一體車_自動攪拌一體機

站內搜索

新聞資訊

公司新聞行業動態

熱點

自動上料平口攪拌機多種方量可供選擇

2022-12-23

混凝土自動上料攪拌車的功能有哪些？

2022-12-19

混凝土自動拌料車移動式可自行走戶外施工

2022-12-16

自上料攪拌車企業這么多，買車的時候應該看哪方面？

2022-12-12

關于山汽

聯系人：劉老師

電話：400-879-1999

公司：山東山汽工程機械（集團）有限公司

地址：山東省萊州市206國道與308省道交叉口東南50米

攪拌一體機的輪胎多少時間更換？

所屬分類：公司新聞發布時間：2021-03-23 來源：http://www.sooezi.com/ 瀏覽量：0

隨著獨立式攪拌機的成本不斷增加，輪胎的價格也隨之增加。

As the cost of stand-alone mixers increases, so does the price of tires.

1.輪胎胎面深度。

1. Tire tread depth.

胎面花紋厚度必須大于1.6毫米。如果在低摩擦的潮濕路面上行駛，請確保胎面花紋厚度是上述值的兩倍。您可以向學習并購買量規以測量胎面花紋的厚度；然而，老駕駛員提出了一種流行的方法來粗略估計胎面花紋的厚度。經常用到。由于從邊緣到頂部的距離為1-2 mm，因此將胎面凹槽向頂部插入。此時，可以看出整個胎面花紋的厚度不足。

The tread thickness must be greater than 1.6 mm. If driving on wet roads with low friction, make sure that the tread thickness is twice the above value. You can learn from experts and buy gauges to measure tread thickness; however, veteran drivers have come up with a popular method to roughly estimate tread thickness. It's often used. Since the distance from the edge to the top is 1-2 mm, insert the tread groove towards the top. At this time, it can be seen that the thickness of the whole tread pattern is insufficient.

2.花紋磨損指示線。

2. Indication line of pattern wear.

與過去的舊胎面花紋磨損指示器相比，新輪胎設計更加人性化。如果輪胎是很新的輪胎或磨損很少，則這些指標幾乎可以忽略不計，但是當磨損達到一定程度時，這些隱藏在胎面花紋溝中的線條就會出現。胎面花紋磨損指示線是沿著胎面的長度垂直地嵌入胎面凹槽中的扁平橡膠條。檢查輪胎，有時會發現一條或兩條指示線導致胎面花紋厚度顯著減小。在這種情況下，請在濕滑的路面上行駛時要小心。如果輪胎上幾乎所有的指示線都清晰可見，則意味著需要盡快更換輪胎。

Compared with the old tread wear indicator, the new tire design is more humanized. If the tire is very new or has little wear, these indicators can be ignored. However, when the wear reaches a certain level, these hidden lines will appear in the tread groove. The tread pattern wear indicator line is a flat rubber strip vertically embedded in the tread groove along the length of the tread. When checking a tire, it is sometimes found that one or two indicator lines result in a significant reduction in tread thickness. In this case, be careful when driving on wet and slippery roads. If almost all the indicator lines on the tire are clearly visible, it means that the tire needs to be replaced as soon as possible.

3.輪胎胎側裂紋。

3. Tire sidewall crack.

并非所有的輪胎問題都集中在胎面中，輪胎側壁有一些問題。尋找輪胎側壁上的可見裂紋或切口。這些小凹槽表明輪胎將來可能會漏氣，更糟糕的是，輪胎可能會爆裂。我們要避免這些輪胎的故障。因此，如果輪胎胎側裂紋看起來更嚴重，請將車輛開到修理廠并盡快更換輪胎。

Not all tire problems are concentrated in the tread, and there are some problems in the sidewall. Look for visible cracks or cuts in the tire sidewall. These small grooves indicate that the tire may leak in the future, and worse still, the tire may burst. We need to avoid these tire failures. Therefore, if the tyre sidewall crack looks more serious, please drive the vehicle to the repair shop and replace the tyre as soon as possible.

4.輪胎脹大和脹大。

4. Tire swell and swell.

在某些情況下，由于強度不足，輪胎的外表面可能會升起并在普通輪胎的表面上方起泡。輪胎面臨類似情況。如果未及時將車輛送往修理廠且輪胎及時失效，則胎面強度不足的區域可能會突然高速爆裂。輪胎破裂甚會對駕駛員或乘客造成嚴重傷害。

In some cases, due to insufficient strength, the outer surface of the tire may rise and blister over the surface of a normal tire. Tires face a similar situation. If the vehicle is not sent to the repair shop in time and the tire fails in time, the area with insufficient tread strength may suddenly burst at high speed. Tire rupture can even cause serious injury to the driver or passengers.

特別是在路況惡劣的情況下，駕駛車輛時不可避免地會發生一定程度的抖動。通過一些駕駛經驗，您可以感覺到抖動在合理范圍內，并且可以感覺到抖動表明車輛出現故障。

Especially in the case of bad road conditions, a certain degree of shaking will inevitably occur when driving the vehicle. Through some driving experience, you can feel that the shaking is within a reasonable range, and you can feel that the shaking indicates that the vehicle is faulty.

上一頁：如何檢查自動攪拌一體車的防抱死系統？下一頁：多功能攪拌車如何防止水箱粘在一起？

熱門產品 / HOT PRODUCT